3Com Switch 5500 Family
Quick Reference Guide
ospf authentication-mode
Using the
ospf authentication-mode
command, you can configure the authentication mode and key
between adjacent routers.
VLAN Interface view
The passwords for the authentication keys of routers on the same network segment must be identical. In
addition, if you use this command with the
authentication-mode
command, you can set the authentication
type of an area (see Example). By default, the interface does not authenticate the OSPF packets.
ospf cost
Using the
ospf cost
command, you can configure the cost of sending traffic from each interface.
VLAN Interface view
ospf dr-priority
Using the
ospf dr-priority
command, you can configure the priority for electing the "designated router"
on an interface.
VLAN Interface view
ospf mib-binding
Using the
ospf mib-binding
command, you can bind the MIB operation to the specified OSPF process.
System view
ospf mtu-enable
Using the
ospf mtu-enable
command, you can enable the interface to write the MTU value when sending
DD packets.
VLAN Interface view
ospf network-type
Use the
ospf network-type
command to configure the network type of OSPF interface.
VLAN Interface view
ospf timer dead
Using the
ospf timer dead
command, you can configure the amount of dead time allowed to OSPF
neighbors, in seconds.
VLAN Interface view
ospf timer hello
Using the
ospf timer hello
command, you can configure the Hello interval time allowed for an interface.
VLAN Interface view
ospf timer poll
Using the
ospf timer poll
command, you can configure the Hello packet poll interval.
VLAN Interface view
ospf timer retransmit
Using the
ospf timer retransmit
command, you can configure the interval before LSA re-transmission
on an interface.
VLAN Interface view
ospf trans-delay
Using the
ospf trans-delay
command, you can configure the LSA transmission delay on an interface.
VLAN Interface view
packet-filter
Use the
packet-filter
command to add packet filtering action to the QoS profile.
QoS Profile view
packet-filter
Use the
packet-filter
command to activate the ACL on a specific interface.
Ethernet Port view
parity
Use the
parity
command to configure the parity mode on the AUX (Console) port.
User Interface view
This command can only be performed in the AUX User interface view.
passive
Use the
passive
command to set the data transmission mode to be passive mode.
FTP Client view
password
Use the
password
command to configure a password display mode for local users.
Use the
undo password
command to cancel the specified password display mode.
Local User View
