Setting Up A RADIUS Server
393
i
Open up a command prompt (
Start
>
Run
, enter
cmd
). Enter
secedit
/refreshpolicy machine_policy
. The command may take a few minutes to
take effect.
6
Setup the Internet Authentication Service (IAS) RADIUS Server
a
Go to
Programs
>
Administrative Tools
>
Internet Authentication Service
,
right-click
Clients
, and
Select New Client
.
b
Enter a name for your device that supports IEEE 802.1x. Click
Next.
c
Enter the IP address of your device that supports IEEE 802.1x, and set a shared
secret. Select
Finish
. Leave all the other settings as default.
d
Right-click
Remote Access Policies
, and select
New Remote Access Policy
.
e
Give the policy a name, for example EAP-TLS, and select
Next
.
f
Click
Add...
g
Set the conditions for using the policy to access the network.
Select
Day-And-Time-Restrictions,
and click
Add...
Click
Permitted
, then
OK.
Select
Next
.
Summary of Contents for SuperStack 4
