3Com 4500G 3CR17761-91, Quick Reference Manual

Page: 3 / 52

3Com Switch 4500G Family 3
Command Reference
acl
Use the
acl
command enter ACL view. If the ACL does not exist, it is created first.
System view
acl
Use the
acl
command to apply an ACL to filter Telnet users.
User Interface view
activation-key
Use the
activation-key
command to define a shortcut key for starting a terminal session.
User Interface view
active region-configuration
Use the
active region-configuration
command to activate the settings of an MST (multiple spanning
tree) region.
MST Region view
add-member
Use the
add-member
command to add a candidate device to a cluster.
Cluster view
administrator-address
Use the
administrator-address
command to set the MAC address of the management device on a
member device.
Cluster view
apply cost
Use the
apply cost
command to set the cost for routing information.
Routing Policy view
apply cost
apply ip-address next-hop
Use the
apply ip-address next-hop
command to set the next hop for IPv4 routing information.
Routing Policy view
apply ipv6 next-hop
apply poe-profile
Use the
apply poe-profile
command to apply the existing PoE Profile configuration to the specified
Ethernet port.
PoE Interface view
apply poe-profile interface
Use the
apply poe-profile interface
command to apply the PoE configuration file to one or more PoE
interfaces.
System view
apply preference
Use the
apply preference
command to set preference for routing protocol.
Routing Policy view
apply preference
apply tag
Use the
apply tag
command to set specified tag value of routing information.
Routing Policy view
apply tag
arp check enable
Use the
arp check enable
command to enable ARP entry checking, preventing the device from learning
multicast MAC addresses.
System view
arp max-learning-num
Use the
arp max-learning-num
command to set the maximum number of ARP entries that an interface can
learn.
VLAN Interface view
arp static
Use the
arp static
command to configure the static ARP entry in the ARP mapping table.
System view
arp timer aging
Use the
arp timer aging
command to set the aging timer for dynamic ARP entries.
System view