3Com 400 Family, Configuration Manual

Page: 259 / 344

Logging Function 257
Table 305 Turn on/off the Information Synchronization Switch of every Switch
You can turn on/off the synchronization Switch of the specified information on the
specified Switch as needed.
Displaying and Debugging Info-Center
After the above configuration, performing the
display
command in any view, you
can view the running state of the info-center. You can also authenticate the effect
of the configuration by viewing displayed information. By performing the
reset
command in User View, you can clear the statistics of info-center.
Perform the following operation in User View. The
display
command still can be
performed in any view.
Figure 70 Displaying and Debugging Info-center
Configuration Examples
of Sending Log to Unix
Loghost
Networking Requirement
The networking requirements are as follows:
■
Sending the log information of the Switch to Unix loghost
■
The IP address of the loghost is 202.38.1.10
■
The information with the severity level above informational will be sent to the
loghost
■
The output language is English
■
The modules that allowed to output information are ARP and IP
Operation Command
Turn on the information
synchronization Switch of the
specified Switch
info-center switch-on { unit-id |
master | all } [ debugging | logging
| trapping ]*
Turn off the information
synchronization Switch of the
specified Switch
undo info-center switch-on { unit-id
| master | all } [ debugging |
logging | trapping ]*
Operation Command
Display the content of information
channel
display channel [ channel-number |
channel-name ]
Display configuration of system log and
memory buffer
display info-center
Clear information in memory buffer
reset logbuffer
Clear information in trap buffer
reset trapbuffer