3Com 400 Family, Configuration Manual

Page: 255 / 344

Logging Function 253
Perform the following operation in System View:
Table 294 Defining the Information Source
modu-name
specifies the module name;
default
represents all the modules;
level
refers to the severity levels;
severity
specifies the severity level of information.
The information with the level below it will not be output.
channel-number
specifies the channel number and
channel-name
specifies the channel name.
When defining the information sent to the log buffer,
channel-number
or
channel-name
must be set to the channel that corresponds to the Console
direction.
Every channel has been set with a default record, whose module name is
default
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there
is no specific configuration record for a module in the channel, use the default
one.
If you want to view the debugging information of some modules on the Switch,
you must select
debugging
as the information type when configuring the
information source, meantime using the
debugging
command to turn on the
debugging Switch of those modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in System View.
Table 295 Configuring the Output Format of Time-stamp
Sending the Information
to the Trap Buffer
To send information to the trap buffer, follow the steps below:
1 Enabling info-center
Perform the following operation in System View.
Table 296 Enabling/Disabling Info-center
Operation Command
Define information
source
info-center source { modu-name | default } channel
{ channel-number | channel-name } [ { log | trap |
debug }* { level severity | state state }* ]
Cancel the
configuration of
information source
undo info-center source { modu-name | default }
channel { channel-number | channel-name }
Operation Command
Configure the output format of
the time-stamp
info-center timestamp { log | trap |
debugging } { boot | date | none }
Output time-stamp is disabled
undo info-center timestamp { log |
trap | debugging }
Operation Command
Enable info-center
info-center enable
Disable info-center
undo info-center enable