3Com 3CRWEASYA73 / WL-575, User Manual, Page: 215 / 335

6-83
Using the Command Line Interface
• ip-addr - Specifies the IP address of the management station to receive
notifications.
• sec-name - The defined SNMP v3 user name that is to receive
notifications.
• version - The SNMP version of notifications. Currently only version 3 is
supported in this command.
• udp-port - The UDP port that is used on the receiving management
station for notifications.
• notification-type - The type of notification that is sent. Currently only
TRAP is supported.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• The access point supports up to 10 SNMP v3 target IDs.
• The SNMP v3 user name that is specified in the target must first be
configured using the snmp-server user command.
Example
snmp-server filter
This command configures SNMP v3 notification filters. Use the no form to delete
an SNMP v3 filter or remove a subtree from a filter.
Syntax
snmp-server filter < filter-id > < include | exclude > < subtree >
[ mask { mask }]
no snmp-server filter < filter-id > [ subtree ]
• filter-id - A user-defined name that identifies an SNMP v3 notification
filter. (Maximum length: 32 characters)
• include - Defines a filter type that includes objects in the MIB subtree.
• exclude - Defines a filter type that excludes objects in the MIB subtree.
• subtree - The part of the MIB subtree that is to be filtered.
• mask - An optional hexadecimal value bit mask to define objects in the
MIB subtree.
AP(config)#snmp-server targets mytraps 192.254.2.33 chris
AP(config)#