8
Called number
CLIP
SIM card position number
SIM card IMSI or SCID
High number of connected calls –
owing to a very short GSM call connecting (routing)
time and intelligent call rerouting in the event of failure, the ATEUS - BLUESTAR features high
call time per month (traffic volume of over 250,000 minutes/month). The connectivity depends
on the ATEUS - BLUESTAR configuration and GSM network capacity of course.
SMS receive/send support –
the ATEUS - BLUESTAR helps send and receive SMS in
the PDU format. An intelligent SMS sending over a selected GSM network or module and
automatic announcement of incoming SMS are a matter of course. With the RCU it is possible
to send ATEUS – BLUESTAR status info SMS.
Up to 8 GSM groups –
you can define up to 8 independent SIM card groups in the
system. For example, one GSM group can contain one provider‘s SIM cards.
Up to 16 GSM modules –
the ATEUS - BLUESTAR is a modular system where 1 to 8
GSM boards with two GSM modules each can be installed. The GSM boards are hot-
swappable, i.e. can be replaced easily during operation.
Up to 64 SIM cards –
each GSM board contains 8 SIM card holders. However, two SIM
cards are only connected to the GSM modules at one moment. An intelligent SIM card switching
according to time, at random intervals, according to completed minutes or sent SMS enables a
client-oriented approach. A defective SIM card blocking is a matter of course.
Triband –
GSM boards are currently available with GSM modules from Siemens MC45i
modules are suitable for 900MHz, 1800MHz and 1900MHz GSM networks.
One antenna per system only
– One
receive/transmission antennas can be used in
combination with an antenna splitter (see below) for all of up to 16 GSM modules.
Hot-swappable boards –
as mentioned above, all GSM boards are hot-swappable. As a
matter of course, the access to the GSM board can be restricted upon the user‘s request. This
solution provides an easy SIM card replacement during operation.
Support of external Callback –
ATEUS – BLUESTAR supports to make call to GSM and
after connection make call to PRI interface and connect both calls. This feature can be
controlled by AT command or XAPI server SW (easy to implement it to some additional callback
SW)
2x PRI ISDN interface –
is configurable in all available modes, i.e. as Network
Termination (NT), or Terminal Equipment (TE). It can also be set as a Master (synchronization
clock) or a Slave. Using PRI board switches you can easily select RX and TX directions –
hence, you can use a cross-over or not-cross-over cable for the ATEUS - BLUESTAR <> PBX
(Switch) connection.
Easy control and configuration –
The ATEUS - BLUESTAR can be configured locally or
remotely. To do this, you can employ the following types of connection:
•
2 local RS232 interfaces;
