26
8.4. BLUESTAR Installation
•
Place the BLUESTAR into an environment that corresponds with its working conditions.
•
Configure the BLUESTAR properly using the configuration software included.
•
The BLUESTAR mains supply must be backed-up and overvoltage protected.
•
For a more comfortable gateway administration, it is advisable to have one of available
remote control tools on site (ISDN line, analog line, Ethernet).
8.4.1. BLUESTAR Control Ways
The BLUESTAR can be supervised and controlled locally or remotely as follows:
A.
Local control using a PC connected by a standard serial cable available with the
BLUESTAR .
B.
Remote control using an analog or ISDN modem connected to the BLUESTAR
COM2 (the modem initialization commands have to be selected correctly – refer to
BLUESTAR configuration>BLUESTAR program).
C.
Remote control over the IP network using a standard Telnet protocol,
or SNMP*,
HTTPS* protocols.
Here, be sure to set the IP address and IP mask properly – refer
to BLUESTAR configuration>BLUESTAR program).
D.
Remote control via B-channel of PRI connection
*This function is optional function (with RCU)
8.4.2. BLUESTAR Configuration
The BLUESTAR can be configured by any of the following two ways:
A.
using AT commands (refer to Appendix A);
B.
using the BLUESTAR program.
C.
using the BLUESTAR wizard (for settings basic parameters)*
*actually not available.
A PC can be used for both the ways, either locally (via a serial cable), or remotely with a
modem, using the Telnet protocol over IP, or via B-channel.
Since the BLUESTAR is constantly upgraded, you are advised to use the latest BLUESTAR
software firmware versions.
8.4.3. Your first installation (quick step by step quide)
1/ Connect the gateway with PC via RS232 cable
2/ Install&Run from attached CD the BLUESTAR program
3/ In top menu open parameter C
OMMUNICATION
, S
ETTING
and select right COM port where is the
BLUESTAR connected (description on page
Chyba! Záložka není definována.
4/ Section S
YSTEM
, S
YSTEM
S
ETTINGS
(description on page
Chyba! Záložka není definována.
Chyba! Nenalezen zdroj odkazů.
-
add IP address and IP mask of the BLUESTAR (In case that you want to make
remote control via IP)
-
Set PIN code (for case that you have on SIM cards enabled PIN code)
!!! WARNING – IN CASE THAT YOU HAVE SIM CARD WITH ENABLED PIN - ALL
SIM CARDS MUST HAVE SAME PIN CODE AS PIN CODE IN BLUESTAR !!!
-
Set parameter G
ENERAL SELECTION OF
SIM
CARDS
to “According to GSM groups”
5/ Section ISDN, B
ASIC
P
ARAMETERS
(description on page
Chyba! Záložka není definována.
