ZyXEL Communications VES-1000 Series, Руководство пользователя, Страница: 27 / 227

VES-1000 Series Ethernet Switch
Hardware Connections 2-1
Chapter 2
Hardware Connections
This chapter gives a brief introduction to the VES hardware.
2.1 Additional Installation Requirements
In addition to the contents of the package, you need the following hardware and software components before you
install and use your product:
•
A computer with a 10/100M Ethernet NIC (Network Interface Card)
•
A computer with terminal emulation software configured to the following parameters:
VT100 terminal emulation
9600 bps
No parity, 8 data bits, 1 stop bit
No flow control
2.2 Back Panel
The following figure shows the back panel for the VES-1012 only. There are no sockets or switches on the back
panel of the VES-1008A.
Figure 2-1 VES-1012 Back Panel
2.2.1 Power Connector
Make sure you are using the correct power source.
The VES-1008A has the power receptacle located on the front panel. This allows for the convenient placing of the
unit in locations where space may be a limitation. To connect the power to the unit, insert the female end of power
cord to the power receptacle on the front panel. Connect the other end of the supplied power cord to a power outlet.
To connect the VES-1012 only, plug the female end of the power cord to the power receptacle on the rear panel.
Connect the other end of the cord to a power outlet. Make sure that no objects obstruct the airflow of the fans
(located on the side of the unit).