ZyXEL Communications VES-1000 Series, Руководство пользователя, Страница: 123 / 227

VES-1000 Series Ethernet Switch
Port Setup 16-3
Table 16-1VDSL Port Setup
FIELD DESCRIPTION EXAMPLE
Active The factory default of all VDSL ports is disabled. A port must be enabled for data
transmission to occur. Press [SPACE BAR] to select
Yes and press [ENTER] to
enable the specified VDSL port.
Yes
Type This read-only (r.o.) field displays the type of port you are currently configuring.
(Ethernet Ports 13 and 14 relate to the VES-1012 only). VDSL
VDSL Mode VDSL mode can be configured per port. Press [SPACE BAR] and then press
[ENTER] to choose from
10BaseS , ETSI Plan 997 , ANSI/ETSI Plan 998 or
Special_Mode .
10BaseS
Speed:
Rate Adaption Press [SPACE BAR] once to select Yes (if not already selected) and then press
[ENTER] to enable rate adaption.
To view the actual DSL transmission rate attained on the VDSL line, enter 24 from
the main menu, then enter 1 to open
Menu 24.1 — System Status and finally
enter 1 again to open Menu 24.1.1 — System Maintenance — System Status .
Yes
Max. Upstream Press [SPACE BAR] to cycle through the upstream speeds. Speeds available
depend on the VDSL Mode chosen in Menu 2 – Switch Setup .
18750K
Max.
Downstream
Press [SPACE BAR] to cycle through the downstream speeds available for the
VDSL Mode chosen in Menu 2 – Switch Setup .
16667K
Edit Filter Press [SPACE BAR] once to select Yes and then press [ENTER] to go to Menu
6.1.4 – Edit Filter .
No
Edit Spanning
Tree Protocol
Setup Press [SPACE BAR] once to select Yes and then press [ENTER] to go to Menu
6.1.1 - Port Spanning Tree Protocol Setup . You must enable STP on the switch
(in menu 2) before you configure it on a port(s). Note that you very rarely need to
enable STP on VDSL ports since the VDSL ports are directly connected to the
users.
No
Edit VLAN
Setup You only see this field if you’ve selected 802.1Q VLAN Type in menu 2. Press
[SPACE BAR] once to select Yes and then press [ENTER] to open Menu 6.1.3 —
Port VLAN Setup .
No
Default Port
Priority The Default Port Priority value is added to incoming frames without a (802.1p)
priority tag. The default is 0 . Use this field to define the default priority of each
port.
0
Limiting number
of MAC address Use this field to limit the number of (dynamic) MAC addresses that may be
learned on a VDSL port. For example, if you set this to “5” on port 2, then only the
devices with these five learned MAC addresses may access port 2 at any one
time. A sixth device would have to wait until one of the five learned MAC
addresses aged out. MAC-address aging out time can be set in menu 2. The valid
range is from 0 to 254. 0
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save your
configuration, or press [ESC] at any time to cancel.
16.1.3 Ethernet Port Setup
Ethernet port connections can be half duplex or full duplex. The Ethernet port must use the same speed / duplex
mode setting as the peer Ethernet port in order to connect.