ZyXEL Communications VES-1000 Series, Руководство пользователя, Страница: 159 / 227

VES-1000 Series Ethernet Switch
Firmware and Configuration File Maintenance 21-5
Table 21-3 General Commands for GUI-based TFTP Clients
COMMAND DESCRIPTION
Host Enter the IP address of the VES. 192.168.1.1 is the VES’s default IP address when shipped.
Send/Fetch Use “Send” to upload the file to the VES and “Fetch” to back up the file on your computer.
Local File Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom
extension) on your computer.
Remote File This is the filename on the VES. The filename for the firmware is “ras” and for the configuration
file, is “rom-0”.
Binary Transfer the file in binary mode.
Abort Stop transfer of the file.
Refer to section 21.2.5 to read about configurations that disallow TFTP and FTP over WAN.
21.2.9 Backup Via Console Port
Back up configuration via console port by following the HyperTerminal procedure shown next. Procedures using
other serial communications programs should be similar.
1.
Display menu 24.5 and enter “y” at the following screen.
Figure 21-3 System Maintenance - Backup Configuration
2.
The following screen indicates that the Xmodem download has started.
Figure 21-4 System Maintenance - Starting Xmodem Download Screen
3.
Run the HyperTerminal program by clicking Transfer , then Receive File as shown in the following
screen.
Figure 21-5 Backup Configuration Example
4.
After a successful backup you will see the following screen. Press any key to return to the SMT menu.
Ready to backup Configuration via Xmodem.
Do you want to continue (y/n):
You can enter ctrl-x to terminate operation any
time.
Starting XMODEM download...
Type a location for storing the
configuration file or click
Browse to
look for one.
Choose the Xmodem protocol.
Then click Receive .