ZyXEL Communications VES-1000 Series, Руководство пользователя, Страница: 114 / 227

VES-1000 Series Ethernet Switch
15-2 General, Switch and IP Setup
Figure 15-2 Menu 2 - Switch Setup (VES-1012)
Table 15-2 Menu 2 – Switch Setup
FIELD DESCRIPTION EXAMPLE
Ethernet Port 13 and Port
14 Trunking Ethernet port trunking is disabled by default. Press [SPACE BAR],
select
Yes , and then press [ENTER] to allow trunking (make sure the
remote switch also supports trunking).
Enable trunking (press [SPACE BAR], select Yes) only if you connect
both Ethernet ports to a single switch (VES-1008A Ethernet ports 8
and 9 are equivalent to Ethernet ports 13 and 14 in the VES-1012).
No
Edit Spanning Tree
Protocol Press [SPACE BAR] once to select Yes and then [ENTER] to display
Menu 2.1 - Spanning Tree Protocol Setup .
No
Edit GARP Timer Press [SPACE BAR] once to select Yes and then press [ENTER] to
go to Menu 2.2 — GARP Timer Setup .
No
VLAN Type Press [SPACE BAR] and then press [ENTER] to choose from 802.1Q
or Port-Based . To enable IEEE 802.1Q on the VES, you must
configure it for the switch in this menu, menu 6 port submenu(s) and
menu 17 VLAN setup. Menu 17 is not applicable (N/A) if you choose
port-based VLANs for the switch in menu 2.
802.1Q
IGMP Snooping Press [SPACE BAR] once to select Enable and then press [ENTER].
Press [ENTER] again at the message “Press ENTER to Confirm…“ to
activate IGMP snooping on the device.
Disable
Edit QoS Support Press [SPACE BAR] once to select Yes and then press [ENTER to
go to Menu 2.3 — QoS Setup .
No
Aging Time Setting Enter a time from 0 to 1700 seconds. This is how long all dynamic
MAC addresses remain in the MAC Address Table before they age
out (and must be relearned). 300
Port Mirroring Port Mirroring allows you to copy traffic from a VDSL port to an
Ethernet port in order that you can examine the VDSL traffic from the
Ethernet port.
Press [SPACE BAR] once to select Enable and then press [ENTER
to allow port mirroring. Select the port that examines this “snooped”
port and the port you want to sniff in the next two fields.
Both the Ethernet port and the VDSL port must be in the same VLAN.
Disable
Snoop Port Press [SPACE BAR] to cycle through the choices and then press
[ENTER] to select an Ethernet port that will monitor a VDSL port.
Menu 2 - Switch Setup
Ethernet Port 13 and Port 14 Trunking= No
Edit Spanning Tree Protocol= No
Edit GARP Timer= No
VLAN Type= 802.1Q
IGMP Snooping= Disable
Edit QoS Support= No
Aging Time Setting= 300
Port Mirroring= Disable
Snoop Port= N/A
Monitored Port= N/A
Broadcast Storm Control= 32 Frames