ZyXEL Communications UAG2100, Руководство пользователя

Страница: 523 / 617

Chapter 46 System
UAG Series User’s Guide
523
46.9 Telnet
You can use Telnet to access the UAG’s command line interface. Specify which zones allow Telnet
access and from which IP address the access can come.
46.9.1 Configuring Telnet
Click Configuration > System > TELNET to configure your UAG for remote Telnet access. Use
this screen to specify from which zones Telnet can be used to manage the UAG. You can also specify
from which IP addresses the access can come.
Figure 366
Configuration > System > TELNET
The following table describes the labels in this screen.
Table 245
Configuration > System > TELNET
LABEL DESCRIPTION
Enable Select the check box to allow or disallow the computer with the IP address that matches
the IP address(es) in the
Service Control table to access the UAG CLI using this service.
Server Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Service Control This specifies from which computers you can access which UAG zones.
Add Click this to create a new entry. Select an entry and click Add to create a new entry after
the selected entry. Refer to Table 242 on page 506 for details on the screen that opens.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove . The UAG confirms you want to remove it
before doing so. Note that subsequent entries move up by one when you take this action.
Move To change an entry’s position in the numbered list, select the method and click Move to
display a field to type a number for where you want to put it and press [ENTER] to move
the rule to the number that you typed.