Zte ZXC10-BTSB I2, Руководство по установке

Страница: 160 / 178

ZXC10-BTS (V5.4) Installation Manual
13-2
9. Each stand should be equipped with 4 partition insulators. If installed close to
walls, some of them should be placed between each stand and walls to make a
cabinet and walls insulated.
10. The stand supporter should be consistent with the hole sites of expansion
screws.
11. The upper plane of the conductive floor in the equipment room is no higher than
the lower surface of the stand lest the thermolysis of a stand should be affected.
12. After all cables are laid out, the small cover plates of the wire outlets at the set
top should be pushed forward to cover the wire outlets and prevent rodents
entering the cabinet.
13. In case of a combined cabinet, check whether the cabinets are well arranged and
connecting pieces at the combined set top should be firmly installed.
14. The surface of the integrated equipment should be clean and tidy and the paint
outside it should be in good condition. The identifications should be correct,
clear and complete.
15. The front door of a cabinet must be easily opened or closed.
13.2 Check of cabling rack
In terms of a cabling rack, the hardware installation check is required as follows:
1. The location and height of the cabling rack should meet engineering design
requirements.
2. The flat steel of the cabling rack should be flat and straight, without any
apparent warping or skewness.
3. Each cabling rack should be equipped with a ground wire. All points of
connection should be superior in electrical performance and they are well
connected with the grounding body in the equipment room.
13.3 Laying, Binding and Identification of Cables
As follows are the principles of laying and binding cables: