Zte ZXC10-BTSB I2, Руководство по установке

Страница: 110 / 178

ZXC10-BTS (V5.4) Installation Manual
9-6
B-B
Pinouts of
25-pin male
connector
End A
Green
30
10m
Label
B
B
1
2
3
4
Upper part of
the smoke sensor
(b)
(a)
( c)
End B
Red
Label
Lower part of
the smoke sensor
Green wire
Red wire
Fig. 9.2-1 Installing the Smog Sensor Base
Table 9.2-1 Terminal Connection of the Smog Sensor Cable Connector
Signal 25-pin Male Connector at End A Cable Color Smog Sensor Base at End B
+12V 10 Red 3(+)
-12V 11 Green 1(-)
9.2.2 Installing the Indoor Temperature/Humidity Sensor
The temperature/humidity sensor is mounted on the wall. Select a proper position on
the wall in the equipment room, drill a hole of Φ 6, put in a rubber cork, tighten the
captive screw, and finally hang the sensor on the wall through the hole. The dimensions
of the sensor is as shown in b of Fig. 9.2-2.
Both ends of the sensor connection line are DB9 connectors. As shown in a of Fig.
9.2-2, connect the DB9 male connector at end A to the DB9 socket, the
temperature/humidity socket on the BTS set top. And connect the DB9 female
connector at end B to the sensor.
The terminal connection of the cable connector is described in Table 9.2-2.