zortrax Apoller, Руководство пользователя

Страница: 8 / 62

©2019, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection
8
Electrical Safety
Use only the original power cable supplied with the device. Do not damage, cur or repair
the cable. A damaged cable should be immediately replaced with a new one. The cable
should be used according to its intended purpose and should be protected from heat,
oils, sharp edges and moving components of the device. A damaged cable increases the
risk of an electric shock.
Protect the device against rain and humidity. Be careful not to spill the liquid outside the
filler. Liquids spilled into the device increase the risk of an electric shock.
To ensure the highest safety standards, including protection against short circuit, over-
load, over voltage and device overheating, do not attempt to modify the device and do not
use replacement parts other than those recommended by the Manufacturer.
Before plugging the power cable into the outlet, make sure that the power supply voltage
in the outlet matches the required value provided on the nameplate at the back of the
device. Avoid overloading the outlet with too many devices.
The device must be well-grounded. Always make sure that the ground complies with local
and national regulations.
Repair work can only be carried out by the Manufacturer or the Manufacturer’s Authorized
Service.
All maintenance activities should be carried out when the device is off and unplugged.
Always follow the instructions included in this User Guide.
Mechanical Safety
All mechanical components in the Zortrax Apoller are covered and protected against the
possibility of touching. However, you should not block the device’s ventilation openings or
put any objects in them.
Tools and accessories delivered with the device should be used with special care only for
intended purposes. Improper use may cause serious injuries.
While following post-processing procedures, wear safety gloves and glasses to avoid in-
juries that may be caused by sharp edges and fragile elements of models.
If it is particularly difficult to remove a print from the platform after the smoothing pro-
cess, at first take out the platform and remove the print outside the device using a spatula.
The platform is made of glass, therefore, be particularly careful during the assembly and
disassembly process.