Zontes ZT310M 2022, Руководство по обслуживанию

Страница: 80 / 88

③ Assembly
The chain surface is sprayed, and the chain end is still set on the timing chain teeth according to the above figure,
and the other end is pulled out from the sprocket chamber and straightened the chain from falling off.
2, Remove the tightness
(Tension tight disassembly refer to ZT310T-M engine repair manual - cylinder head cover, cylinder head -
tight)
3, Disassembly guide strip pressure plate
①
Disassembly
Use the tool 1 or 2 to remove the pressed bolt, take the pressure plate.
②
Check
If the platen is deformable or broken, it should be replaced.
③ Assembly
Install the pressure plate as shown in the illustrated position, bolt applied to
the threaded glue, screw into the pressed bolt hole and tighten the tool 1, and the tightening torque is 10 ± 1 N.m.
4, Disassemble the trapezoidal thick filter
①
Disassembly
Remove the trapezoidal rough filter with a flat clamp (or other tool with a flat
clamping function) (preventing the deformation of the crude filter) to remove the
trapezoidal crust with a mild solvent.
②
Check
If the filter is broken, it should be replaced.
③
Assembly
Put the crust in the cabinet according to the illustration and press it in place (there is a font identification side facing
down, do not load the wrong direction).
5, Decomposition crankcase
①
Remove the start motor with tool 1 or tool 2 as shown below.
②
Tool 1 or Tool 2 Agimifier is uniformly uniformly dismantled, first remove 8 M6 × 75 hex flanged bolts on the left