Zontes ZT310M 2022, Руководство по обслуживанию

Страница: 52 / 88

④
Place the driven wheel flat on the workbench or on a clean ground
,
then make the indicating arrow on the V-
shaped transmission belt point to the counterclockwise rotation direction, place the V-shaped transmission belt on the
outer ring of the driven wheel, and make a certain distance from The moving wheel is 4~5cm away.
Press the driven
wheel clutch housing with the palms of both hands, and the fingers of both hands buckle the moving plate of the
driven wheel while pulling it upwards while rotating it clo ckwise. After the moving plate of the driven wheel is raised
about 10mm in height, quickly extend a finger near the V-belt side to pivot the V-belt into the belt groove between the
driven wheel moving disc and fixed discs. Finally, clamp the middle of the belt with an elastic clip to prevent the belt
from loosening by itself.
Note: This step requires greater hand strength and certain operating experience to complete. Insufficient
hand strength or no operating experience may cause injury to fingers caught by the driven pulley pulley! ! !
⑤
Pick up the combined driven wheel and the V-shaped transmission belt as a whole, with the clutch housing of the
driven wheel facing outwards, and after the center inner hole of the driven wheel is aligned with the drive shaft, push
the driven wheel inward into place (the drive shaft is used for mounting
φ14.5 × φ25 ×16 a section of the optical axis of
the bushing of the driven wheel is exposed), and the other part of the V-shaped transmission belt is sleeved on the
outer ring of the exposed crankshaft spline.
⑥
Main fixing plate with wind blade side facing outwards, the spline hole in the middle is aligned with the splines on
the crankshaft, and then assembled on the crankshaft, and assembled in place.
⑦
Sleeve the φ12.3 × φ40 ×4 washer on the M12×1.25×35 hexagon flange bolt, and then screw the M12×1.25×35
hexagon flange bolt into the crankshaft threaded hole.