Zontes ZT310M 2022, Руководство по обслуживанию

Страница: 27 / 88

4
、
As shown in the figure, check the flywheel T point marking line, After confirming alignment with the right cover
M14 x 1.5 screw plug hole scale, and turn the camshaft so that the dot is aligned with the camshaft pressing plate
bolt.Put the timing driven sprocket into the timing chain and assemble it on the camshaft. At the same time, the
timing of the timing driven sprocket is aligned with the timing mark of the cylinder head.Apply thread glue to the
M6×16 bolts, and tighten the timing sprocket (torque of 12±1.5 N•m). After confirming that it is installed in place,
install the tensioner.
(Refer to ZT310T-M engine service manual for tensioner installation - Cylinder head
cover, cylinder head - Tensioner) .
(Note: After confirming that the timing chain has not fallen off from the timing driving gear, tighten the timing
sprocket with a fixed twist. After installing the tensioner, you need to rotate the crankshaft to recheck the
timing for the second time.)
Seven, Guide bar
Guide strip removal
Before disassembling the guide bar, the following parts need to be disassembled.
· Tensioner. (
Refer to ZT310T-M Engine Maintenance Manual-Cylinder Head Cover, Cylinder Head-Tensioner for
disassembly and assembly )
·The cylinder head cover sub- parts. ( Refer to ZT310T-M Engine Maintenance Manual-Cylinder Head Cover,
Cylinder Head-Cylinder Head Cover for disassembly and assembly
)
·Cylinder head assembly. ( Refer to ZT310T-M Engine Maintenance Manual-Cylinder Head Cover, Cylinder Head-
Cylinder Head for disassembly and assembly )
Align
Align
Tensioner