Zontes ZT310-V1 EURO V, Руководство по обслуживанию

Страница: 61 / 110

6
、
COOLING SYSTEM COMPONENT 60
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1224100-051000 0 grade flame retardant cable tie (black 2.5×100) 1
2 1274200-090000 ZT310 Hoop of cooling liquid tube
（
φ26
）
2
3 1251112-002093 M6×30 Hexagon flange bolts (color zinc) 1
4 1244200-068000 ZT310-V engine inlet water pipe 1
5 1274200-041000 ZT310 Cooling liquid tube clamp
（
φ26
）
3
6 1244200-012000 ZT310
－
R Engine cooling liquid passing tube 1
Main water tank assembly 1
Fig.9 COOLING SYSTEM
COMPONENT
PROCEDURE:
●
Main water tank assembly
Locate the connector for the radiator fan and temperature sensor on the left side of the vehicle near the front of
the tank and unplug the connector.
Cut the two straps
⑴
.
Use the pliers to clamp the hoop
⑵
and move the anti-slip boss up to release the hoop.
Using 8#sleeve remove the bolt
⑶
.
Pull out the water pipe after wearing the waterproof gloves. Remove the hoop
⑵
.
Use the pliers to remove the hoop
⑵
on the right side and pull out the engine inlet pipe
⑷
. Close the radiator
end and remove the hoop.
Use a flat-blade screwdriver to loosen the three clamps
⑸
and remove the boss indicated by the arrow.
Remove the inlet pipe
⑷
and the water pipe
⑹
and then remove the clamp
⑸
from the water pipe.
Remove the main tank assembly.
CAUTION:
●
Motorcycle should be well supported.Manipulation should start after the engine is completely cooled down.
●
Manipulation should start after the engine is completely cooled down.
●
Cooling liquid is toxic. Avoid strictly eye or skin contact.
●
Do not disassemble the hoop with too strong force. If not, it will cause permanent deformation and lose
elasticity, which will lead to leakage of cooling liquid.
●
When reassembling, be careful that the clamps and hoops should be prevented from loosening on the inside of
the boss.