background image

2

Performance Data

Each Zoeller Pump Company 600 Series Pump installation is required to have a completed Zoeller Pump Company Start-up Report (FM0990). The 

report is to be completed by an approved Start-up Technician in the presence of the installing contractor. A copy of this report will be on file at 

the Zoeller Pump Company offices in Louisville, KY.  

Failure to comply with the requirement could void the warranty agreement. Refer to page 7 

for pumps that are kept in short term storage.

Limited Warranty

 

Manufacturer warrants, to the purchaser and subsequent owner during 

the warranty period, every new product to be free from defects in material 

and workmanship under normal use and service, when properly used 

and maintained, for a period of one year from date of purchase by the 

end user, or 18 months from date of original manufacture of the product, 

whichever comes first.  Parts that fail within the warranty period, one 

year from date of purchase by the end user, or 18 months from the date 

of  original  manufacture  of  the  product,  whichever  comes  first,  that 

inspections determine to be defective in material or workmanship, will 

be repaired, replaced or remanufactured at Manufacturer's option, 

provided however, that by so doing we will not be obligated to replace 

an entire assembly, the entire mechanism or the complete unit.  No 

allowance will be made for shipping charges, damages, labor or other 

charges that may occur due to product failure, repair or replacement.

This warranty does not apply to and there shall be no warranty for any 

material or product that has been disassembled without prior approval of 

Manufacturer, subjected to misuse, misapplication, neglect, alteration, 

accident or act of nature; that has not been installed, operated or 

maintained in accordance with Manufacturer's installation instructions; 

that has been exposed to outside substances including but not limited to 

the following:  sand, gravel, cement, mud, tar, hydrocarbons, hydrocarbon 

derivatives (oil, gasoline, solvents, etc.), or other abrasive or corrosive 

substances, wash towels or feminine sanitary products, etc. in all pumping 

applications.  The warranty set out in the paragraph above is in lieu of 

all other warranties expressed or implied; and we do not authorize any 

representative or other person to assume for us any other liability in 

connection with our products.

Contact  Manufacturer  at,  3649  Cane  Run  Road,  Louisville,  Kentucky  

40211, Attention: Customer Service Department to obtain any needed 

repair or replacement of part(s) or additional information pertaining to 

our warranty.

MANUFACTURER EXPRESSLY DISCLAIMS LIABILITY FOR SPECIAL, 

CONSEQUENTIAL OR INCIDENTAL DAMAGES OR BREACH OF 

EXPRESSED OR IMPLIED WARRANTY; AND ANY IMPLIED WARRANTY 

OF FITNESS FOR A PARTICULAR PURPOSE AND OF MERCHANTABILITY 

SHALL BE LIMITED TO THE DURATION OF THE EXPRESSED WARRANTY.

Some states do not allow limitations on the duration of an implied warranty, 

so the above limitation may not apply to you. Some states do not allow 

the exclusion or limitation of incidental or consequential damages, so 

the above limitation or exclusion may not apply to you.

This warranty gives you specific legal rights and you may also have 

other rights which vary from state to state.

TOTAL DYNAMIC HEAD/FLOW

PER MINUTE

SEWAGE AND WASTEWATER

MODEL

Feet

Shut-off Head:

611

621

631

Meters

Gal.

Liters

5

1.5

250

946

320

1211

390

1476

10

3.0

185

700

255

965

335

1268

15

4.6

110

416

190

719

272

1030

20

6.1

35

132

125

473

200

757

25

7.6

--

--

60

227

130

492

30

9.1

--

--

--

55

208

35

10.7

--

--

--

40

12.2

--

45

13.7

50

15.2

55

16.7

60

18.2

Gal.

Liters

Gal.

Liters

22 ft.(6.7m)

29 ft.(8.8m)

34 ft.(10.4m)

--
--
--
--
--
--
--

--

--

--

--

--

--

--

--

--

--

--

--

--

--

--

--

--

--

--

--

--

--

--

--

--
--

641 (1PH)

420

1590

370

1401

319

1208

260

984

198

750

130

492

62

235

--

--

--

--

Gal.

Liters

39.5 ft.(12.0m)

--

--

--
--

--
--

641

651

661

460

1741

533

2018

--

--

410

1552

490

1855

590

2233

355

1343

445

1685

555

2101

300

1136

398

1507

510

1931

245

927

350

1325

460

1741

175

662

300

1136

410

1552

115

435

240

908

360

1363

50

189

175

662

305

1155

--

--

115

435

245

927

55

208

175

662

--

--

110

416

45

170

Gal.

Liters

Gal.

Liters

Gal.

Liters

44 ft.(13.4m)

54 ft.(16.5m)

63 ft.(19.2m)

--

--

--
--

--
--

--

--

651 (1PH)

475

1798

440

1666

395

1495

345

1306

290

1098

232

878

165

625

95

360

25

95

--

--

--

--

Gal.

Liters

46.5 ft.(14.2m)

--

--

Feet

Shut-off Head:

Meters

5

1.5

10

3.0

15

4.6

20

6.1

25

7.6

30

9.1

35

10.7

40

12.2

45

13.7

50

15.2

55

16.7

60

18.2

MODEL

LITERS

0

0

50

100

400

150

200

800

250

300

1200

350

1600

400

450

500

550

2000

650

GALLONS

5

2

10

15

4

6

20

25

8

30

10

35

12

40

14

45

50

16

55

18

60

70

FLOW PER MINUTE

TO

TAL D

YNAMIC HEAD

METERS

FEET

PUMP PERFORMANCE CURVE

MODELS 611/621/631/641/651/661

611

621

631

651

661

2400

600

65

20

641

651 1PH

641 1PH

013859

© Copyright 2023 Zoeller

®

 Co. All rights reserved.

In instances where property damages are incurred as a result of an alleged product failure, the property 

owner must retain possession of the product for investigation purpose.  

Содержание E611

























Отзывы: