p.
19/61
4.2.
Installation of the burner
The installation process of the burner should be based on authorized
project, which governs the requirements of acting norms and
recommendations.
In case that the heat consumer unit is solid fuel hot water boiler, that the
requirements are depicted in norm EN 303-5/2000 - „
Heating boilers.
Part 5 : Heating boilers for solid fuels, hand and automatically fired,
nominal heat output of up to 300 kW. Terminology, requirements, testing
and marking
”;
In case that the heat consumer is not hot water boiler, than appropriate
norm and requirements should be governed at preparing the installation
project;
Fire safety requirements;
To the power supply - EN 60335-1/1997 - “
Household and similar
electrical appliances – safety. Part 1. General requirements
”;
4.3.
Overall and attachment dimensions of the burner’s main unit
The installation process of the burner should consider the requirements,
described above, as well the dimensions of the unit, shown on the
following figures.
Figure 4.1.
Isometric view of the main unit of the pellet burner
of series
“GP cs”
–
side views
;
