p. 48/61
Figure 5.12.
Final position of the grate, positioned in the burner’s main module
(
shown as cross-section
)
;
5.9.
Showing and teaching the end user about the maintenance and
adjustment procedures of the burner
It is necessary to show and teach the end user the maintenance procedures
for operating the burner efficiently and keep its reliability in high degree order.
Also the installer should demonstrate and teach the end user how to adjust the
thermal capacity of the burner, according to the estimated heat consumption and
initial fuel transport auger charging:
combustion chamber and grate cleaning
– it is recommended (at
least once per day or a longer period is appropriate) to stop the burner
(turn off the “START” signal of the burner), wait until the char has
been incinerated and the burner cooled down. After the combustion
chamber has been cooled down, remove the grate and clean the ash
residue thoroughly. Use protective gloves and appropriate instruments
if necessary;
ATTENTION
: the
grate is positioned into
its final position and fits
well to the inclined
grate of the burner
