background image

 
 

Revised June 23/10 

 

 

222 Woodland Drive, Vancouver, B.C. V5L 5C8 Ph: (604) 877-1599 Fax: (604) 875-6776 

 

INSTALLATION & MAINTENANCE INSTRUCTIONS 

 

TIKI TORCHES FOR PERMANENT MOUNT 

 

 

 
 

FOR YOUR SAFETY 

 

If you smell gas: 

1. 

Shut off gas to the appliance 

2. Open 

windows 

3. 

Don’t touch electrical switches 

4. 

Extinguish any open flame. 

5. 

Immediately call your gas supplier 

 

 

NOTE:  The installation of these Tiki Torches must conform with local codes or in the absence of local codes, 
with National Fuel Code ANSI 223.1 
 
 
 
 

 

 

 

 

 

1

 
 
 
 

_____________________________________________________________________________ 

FOR YOUR SAFETY 

 
Do not store or use gasoline or other flammable vapors 
and liquids in the vicinity of this or any other appliance. 

TIKI TORCH FOR PERMANENT MOUNT 

(PROPANE) 

 

Burner Screen: 
Stainless Steel 3/32” RD x 5/32 cc 
Perforated 

Содержание TIKI TORCHES

Страница 1: ...open flame 5 Immediately call your gas supplier NOTE The installation of these Tiki Torches must conform with local codes or in the absence of local codes with National Fuel Code ANSI 223 1 1 _____________________________________________________________________________ FOR YOUR SAFETY Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance ...

Страница 2: ...y piping used should be securely fastened to the building or structure with adequate clamps and fasteners It is recommended that each individual head have a manual shut off valve installed up stream and be mounted so that in the closed position the handle is across the piping run These Tiki Torch Cones should not be installed closer than 3 from combustible materials or in accordance with local cod...

Страница 3: ...ame 3 If installed in a public area it is recommended that a lockable gas valve be used 4 All pipe connections should be pressure or soap tested as described in local codes MAINTENACE INSTRUCTIONS 1 Keep the appliance area clear and free from combustible materials gasoline and other flammable vapors and liquids 2 Visually check the burner for soot or blockage on a periodic basis clean if required ...

Страница 4: ...quired Using 54 drill bit for LP and 48 drill bit for NG clean the burner orifices if required 6 Re assemble it is recommended to replace the 1 x 1 16 buna o ring between the hex nuts Call or use the manufactures web site for a dealer nearest to you 7 Fire unit and observe the flame The flame should be a lazy yellow flame with some blue at the base and no visible smoke 4 ...

Отзывы: