OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
29
ZI-STE1800IV
7.
If the oil level is low, refill the recommended oil up to
the upper edge (max. oil level).
8.
Push in the oil dipstick again and tighten.
NOTICE:
overfilling can damage the engine!
17.2.2
Checking the fuel tank level and refuel
N O T I C E
Observe the safety regulations for fuel control. Filter the fuel during refuelling
to prevent foreign particles from entering the combustion chamber. Wipe up leaked
fuel.
H I N W E I S
Fuels are toxic and must not be released into the environment! If
necessary, contact the local authorities for information regarding proper
disposal.
D A N G E R
NEVER REFUEL WHILE THE MACHINE IS RUNNING!
1.
Place the machine on a safe, level surface.
2.
Switch off the engine and set the fuel tap to the "OFF"
position.
3.
Unscrew the fuel tank cap (1).
4.
Check and, if necessary, clean the fuel tank cap filter
(2).
5.
Reinstall the fuel tank cap filter (2). Never refuel
without fuel tank cap filter!
6.
Check the fuel level in the tank.
7.
If necessary, refill with unleaded fuel with the
appropriate octane number (RON 95).
8.
Never fill the fuel tank further than the upper edge of
the fuel tank cap filter (2) (see figure on the left).
9.
Screw the fuel tank cap (1) firmly back on after
refuelling.
18
OPERATION
Information on Initial Start-up
N O T I C E
Note that the machine is delivered without engine oil and fuel. Make sure that
this equipment is filled up before the machine is put into operation for the first time.
ATTENTION: The machine does not start until the engine oil has been
refilled to the upper limit.
