S U P E R S P O R T
24
Check the fit of the deck.
The bottom (inside) of the deck should have 2 coats
of epoxy finishing resin on them by now. If not, get it
done first and allow to cure.
Sand or scrape the underside of the deck.
Mix about 3/4 ounce of 30 minute epoxy. Using a
stick or acid brush, coat the tops of the bulkheads,
chines and spines with resin. Only coat the areas
that the deck will cover.
Also coat all around the perimeter of the deck. Be
sure you are working on the inside. Work quickly.
Align and clamp the deck at bulkhead 3.
Then align and clamp the nose, then the sides.
Check all around to make sure that the deck is tight
against the top of the chines and bulkheads.
Tape down any areas needed.
Continue adding tape until the entire deck is in
contact all the way around.
Add weights if needed to get full contact all the way
around.
Take one last look before you walk away.
Allow to cure.
After the deck sheeting is fully cured, give the whole
boat a good sanding with a 150 grit block. Round off
the nose.
You can round off all top corners, but we
recommend just a little rounding of the keel and
bottom chines.
Keep the transom sides and bottom sharp.
