S U P E R S P O R T
20
Keep the bottom corners sharp at this point.
Do not round off the bottom to transom junction,
we need it sharp.
Use epoxy and micro balloons filler to fill any gaps in
the sheeting.
Allow to cure.
With your razor saw, cut all the tabs that are holding
your hull to the building jig.
Carefully cut away and remove the temporary
bulkhead.
Some glue may have seeped in and glued it to the
sides.
You can use pliers and carefully break it away.
Ditch the jig. We don’t need it any more.
Hey, this is really starting to look like something
now!
After you finish admiring your cool new hull, let’s
move on.
Sand the top so that all spines and supports are
flush with the bulkheads.
Trim the building tabs, and sand the tops of the
bulkheads flat.
Reinforce the engine rails as follows:
