S U P E R S P O R T
31
Flex cable
Get the flex cable, drive dog, prop and prop nut.
Put the drive dog on the stub shaft, then the prop.
Engage the drive dog into the prop, and slide this
assembly back until there are about ½ inch of
threads on the stub shaft.
Tighten the drive dog set screw.
Mark the stub shaft at the front of the drive dog.
Remove the dog and prop.
Measure 3/16 inch back from your line, and file a flat
spot, about 1/8 inch wide and 1/16inch deep.
This is for the set screw.
File off any burrs, and put the drive dog back on,
tightening the set screw into the flat.
Put the prop and prop nut on. Slide the flex cable
into the stinger, until the cable gets to the engine.
Slip the cable into the collet. Be sure that the cable
is fully seated into the collet!
