S U P E R S P O R T
12
All chines should match the angle of each bulkhead.
The rear will have very little twist.
The front will have a substantial amount of twist to
match the angle of the bulkhead.
Add a little extra glue at the nose. We need some
strength here.
Double check that all chines are flush with their
respective bulkheads. Allow to cure.
Blending the chines
Before we can glue the side sheeting in place, we
need to make sure the chines are flat. Do this with
your sanding block and fresh 80 grit paper.
Sand the chines, using your sanding block to blend
them at the front.
Check to see if your sanding block sits flat on the
chines at all points. If it does not, the side sheeting
won’t either. The front of the chines will need a little
bit of blending. The rear will need very little.
Sand the front of the keel where the side sheeting
will lay.
O
nly sand enough to get the bevel. Don’t change
the shape of the keel.
The lower chines (LC) will get sanded very little, and
only on the edge.
