S U P E R S P O R T
15
After the sides have cured, sand the rear of
bulkhead 5. Sand the chines and sides flush with
the bulkhead.
Note the correct orientation of the transom. If you
don’t, the holes will be in the wrong position.
Using 30 minute epoxy, glue the transom to the
back of bulkhead 5. Try to match the bottom “vee”,
and leave an equal overhang on the sides.
Clamp until dry.
Bottom Sheeting
Use the angle on the bulkheads to determine the
angle that you hold the sanding block.
Use fresh 80 grit on your sanding block.
This is one of the most critical parts of assembly, as
it sets the shape of the bottom. DO NOT over sand
the chines.
Take your time and sand until the side sheeting is
just flush and no more.
You cannot do this with any kind of power tool.
