S U P E R S P O R T
27
Slip the tube into the shaft brace, thru bulkhead 4
and against the transom.
You will have to slip the tube forward into your pool
noodle flotation to get it started.
With the tubing bend straight up, grab the shaft tube
about 2 inches behind bulkhead 4 and bend it to the
right. Use your thumbs to make this bend a large
radius as well.
Move back 2 inches and bend it parallel with the
center line of the boat.
The bend should be offset about ¼ inch, and should
slip into the transom.
If you did a perfect job, you should be able to
remove the tube without changing any of the bends.
Turn the tube to get it out.
Make sure that your engine mount holes are clear in
the wood rails. Use a ¼ inch bit and our 104 degree
angle adapter as shown.
Reinstall the tube if you removed it.
Mount your engine in place (with collet installed).
Adjust the first bend in the tube so that it lines up
with the collet perfectly.
Grab your flex cable and slip it into the tube.
Adjust the tub so that the cable easily slips in and
out of the collet.
