P R O V E E
24
Glue both H4 parts into place. Make sure there is
Be sure to put wax paper at all glue joints,
otherwise this will be a display only boat.
Glue both H1 parts (H1 marks forward).
Glue in both H3 with the tops flush.
Glue in H1A.
Glue in both H2 parts. They should be flush with the
bottom of H1. Marks face forward.
You can lightly tape the scoop (H1) to keep
everything in place, but not too tightly.
Allow to cure.
The rear hatch is done much the same way.
Glue in all four H10 parts. These are stops that
prevent the front and rear hatches from falling in.
These go against the bottom of the deck supports,
against the transom and against BH4.
Glue the dowels into 4C so that a 1/2 inch extends
from the front.
Put this into BH4
with 1/16 ply spacer SP in place
.
The 1/2 inch of dowel sticking out should face
forward.
