P R O V E E
32
Stinger Drive
Mount the stinger to the transom using the pre-
drilled holes.
We like to use 6-32x1/2 bolts and blind nuts.
Loosen all adjustment screws slightly.
Adjust the stinger so that the flex shaft slides in
without any resistance. This is important. If the shaft
does not go in freely, it will eventually break.
The Zipp 3401 stinger is fully adjustable.
Final adjustment will be done in setup.
Turn fin
The turn fin should be mounted on the extreme right
side of the transom, above the trim tabs. Use the
pre-drilled holes.
We like to use 6-32x1/2 bolts and blind nuts.
Make sure the fin is 90 degrees to the bottom. It will
be canted outward with the hull level.
The ProVee turns much tighter with a turn fin,
although you can run without one.
If you are racing in the offshore category, or using
the PV for sport use, we recommend a fin on each
side, for right and left turns.
Normal heat racing requires only a RH fin.
