P R O V E E
18
Put weights on it, and set aside.
Make sure that the bottom sheet is in contact all the
way around. Clamp the nose.
You can also tack glue the bottom sheets together
at this time. Put a drop of medium CA about every
two inches or so, check that the bottom sheets are
properly aligned, and hit the drop with a shot of
accelerator.
Let’s build the radio box while the glue cures on the
hull.
Radio Box
Remove all of the radio box parts: Two long sides,
two short sides, the top and bottom, as well as the
1/16 ply top.
Lay a piece of plastic wrap or waxed paper on your
bench.
We use Titebond III and glue all of the 1/8 ply parts
at once.
We tape it together to cure for a couple of hours.
Using CA or Titebond III, glue the two long sides
and two short sides to the bottom.
The small sides have a “T” and “R” on them. These
face inside.
The “R” on the short side should be on the same
side as the “R” on the radio box bottom.
