P R O V E E
34
Measure from the back of the stinger to the drive
dog. Subtract 3/8 inch.
This is the length to be cut from the cable.
When we are done, with the cable fully seated in
the collet, the drive dog will have a 3/8 inch gap
from the stinger.
We need this gap, as the cable “winds up” and
shortens under load, and we don’t want the drive
dog to rub the end of the stinger.
Measur
e carefully, as we can’t add to a cable that is
too short!
Carefully cut the cable with a Dremel and cut off
wheel. Deburr the end.
Radio
Laminate all of the servo mount parts as shown.
Make sure that the parts do not slide out of
alignment while curing.
Do not laminate S1 and S1A at this time.
Note that S3 and S4 have their doublers even at the
top.
Glue S1 to S3 and S4 laminates as shown.
Glue the S2 and S2A laminates together so that the
holes line up.
