P R O V E E
31
Trim Tabs
Mount your trim tabs to the transom so that they are
flush or just a hair up from the bottom.
Use the pre-drilled holes.
We like to use 6-32x1/2 bolts and blind nuts.
Use a grinder or disk sander to remove part of the
blind nut, so that it won’t interfere with the hull
bottom. This is only needed for the trim tabs, due to
their low mounting position.
Rudder
Mount the rudder with blind nuts as you have done.
If using our 3413 rudder, be sure to check that the
set screw for the pin is tight. Do this before you put
the rudder blade on.
Make sure the rudder is not slanted right or left.
Use a square on the top of the boat to sight the
rudder for square.
