INSTALLATION AND OPERATING INSTRUCTIONS:
Gripper, pneumatically intelligent, GPP/GPD5000-IL series
39
Zimmer GmbH
●
Im Salmenkopf 5
●
77866 Rheinau, Germany
●
+49 7844 9138 0
●
+49 7844 9138 80
●
www.zimmer-group.com
DDOC00247 / d
EN / 2020-07-20
12. Gripping force charts
INFORMATION:
For information on the gripping force charts, please visit our website.
Zimmer Customer Service is available to provide you with assistance if you have any further questions.
13. Accessories/scope of delivery
INFORMATION:
If any accessories not marketed or authorized by Zimmer GmbH are used, the function of the gripper cannot be
guaranteed.
The accessories from Zimmer GmbH are specifically fitted for the individual gripper.
Please refer to our website for information on corresponding accessories.
14. Maintenance
Maintenance-free operation of the gripper is guaranteed for up to 30 million cycles.
The maintenance interval may shorten under the following circumstances:
Dirty environment
Improper use and use that does not comply with the power specifications.
Observe ambient temperature; lubricants harden faster!
Even though the gripper is, as mentioned, maintenance-free, perform a regular visual inspection to check for any corrosion,
damage or contamination.
We recommend using the Zimmer Customer Service for maintenance and the replacement of seals.
Dismantling and reassembling the gripper without authorization may result in complications, as special installation equip-
ment is required in some cases.
Zimmer GmbH shall not be liable in the event of unauthorized dismantling and reassembling of the gripper or in the event of
any malfunction or damage resulting from this.
15. Transportation/storage/preservation
►
The transport and storage of the gripper must take place exclusively in the original packaging.
►
If the gripper has already been installed on the superordinate machine unit, care must be taken during transport to en-
sure that no unintentional movements can occur. Before commissioning the machine after transport, check all power and
communication connections as well as all mechanical connections.
►
If the product is stored for an extended period, the following points are to be observed:
Ö
Keep the storage location as dust-free and dry as possible.
Ö
Avoid temperature fluctuations/observe and adhere to the temperature range.
Ö
Avoid wind/drafts/water condensation formation.
Ö
Package the product.
Ö
During storage, it must be kept away from direct sunlight.
►
Clean all components. There must be no soiling left on the components.
►
Visually inspect all of the components.
►
Remove all foreign substances.
►
Properly remove potential corrosion spots.
►
Close electrical connections using suitable covers.
16. Decommissioning and disposal
INFORMATION:
When the gripper reaches the end of its operational phase, it can be completely disassembled and disposed of.
The gripper must be completely removed from the machine or system.
The gripper can be disassembled and properly disposed of according to material groups. When disposing of it,
observe the locally applicable environmental regulations and codes and regulations for disposal.
Zimmer Customer Service is available to provide you with assistance if you have any further questions.
