ZIEHL-ABEGG FXD32AM, Руководство по эксплуатации

Страница: 33 / 123

Menu group “ Setting ” (only when needed)
Main menu
Setting
Setting
Protocol
Base setup
Controller Setup
IO Setup
Setting
Setting direct (at Number steps: 0
“
Base setup
”
)
If the setting is to be made during operation directly with the
▼
+
▲
keys, no setting is
necessary here ( setting in operation 1.02 ).
Setting range: Min. Speed - Max. Speed
Factory setting: 50.0 Hz (
Max. Speed)
50.0 Hz
Setting direct
Setting
Setting step (at Number steps: 1 - 5
“
Base setup
”
)
If the setting is to be made during operation directly with the
▼
+
▲
keys, no setting is
necessary here ( setting in operation 1.02 ).
Setting range: 0 - setting nummber steps
Factory setting: 0
When setting a
“
Minimal speed
”
>
|
OFF
|
the output is not switched off in step
“
0
”
!
0
Setting Step
Setting
Min. Speed (basic speed only when needed)
Setting range:
|
OFF
|
→
“
Shutdown Freq.
”
( Motor Setup) -
“
Max. Speed
”
.
Factory setting:
|
OFF
|
OFF
Min. Speed
Setting
Max. Speed (speed limitation only when needed)
Setting range:
“
Max. Frequency
”
( Motor Setup) -
“
Min. Speed
”
Factory setting: 50.0 Hz
50.0 Hz
Max. Speed
Setting in operation 1.02
After installation is completed, only the “ Setting direct ” or “ Setting Step ” setting is visible in the
“
Info
”
menu
group. All other menus are protected by a PIN.
Info
Setting direct (at Number steps: 0
“
Base setup
”
)
Setting range: Min. Speed - Max. Speed
Factory setting: 50.0 Hz (
Max. Speed)
50.0 Hz
Setting direct
The value set by the
▼ ▲
keys is accepted and executed directly ( P key without
function).
Info
Setting step (at Number steps: 1 - 5
“
Base setup
”
)
Setting range: 0 - programmed number steps
Factory setting: 0
When setting a
“
min. speed
”
> OFF the output is not switched off in step
“
0
”
!
5
Setting Step
Switching over to the protected
“
Info
”
menu group takes place automatically after approximately 15
minutes if no key is pressed.
Possibilities for early activation of PIN protection:
•
Execute the
“
Reset
”
function in the
“
Start
”
menu group.
•
By switching the mains voltage off and then on again.
Operating Instructions Fcontrol
–
model series FXDM25/32AM Programming
L-BAL-E212-GB 1451 Index 003 Part.-No.
33/123