Info
Momentarily status for minimum speed cut off
“
ON
”
= switch off, if Setpoint (+/-
“
Min. speed cut off
”
) is reached.
“
OFF
”
= no switch off that means operation with minimum rate of air.
Display for operation with two control circuits:
“
1. Min. speed cut off
”
for control circuit 1
“
2. Min. speed cut off
”
for control circuit 2
OFF
Min. speed cut off
External manual mode active/not active
Info
External Manual mode not active.
Control to sensor on
“
E1
”
and set target value.
50 %
Set external2
Info
External Manual mode active = signal on
“
E2
”
.
- - - - -
Set external2
9.5
Controller Setup
Main menu
Controller Setup
Settings
Protocol
Base setup
Controller Setup
IO Setup
9.5.1
PIN protection activate, PIN 0010
Controller Setup
The adjustments for the installation in the service level can be protected against
unintentional modi
fi
cations. To do this, activate the
“
PIN protection
”
=
“
ON
”
.
In order to simplify the initial start-up operation, the service level in the factory setting is
free =
“
OFF
”
i.e. accessible without
PIN 0010
.
OFF
PIN Protection
Available menu groups with activated PIN-protection
Main menu
Start
Setting
Protocol
If PIN-protection is switched on, it automatically becomes active after about 15 minutes without keys
being pressed.
Possibilities for early activation of PIN protection:
•
Execute the
“
Reset
”
function in the
“
Start
”
menu group.
•
By switching the mains voltage off and then on again.
Information
After installation of the device has been carried out,
“
PIN-Protection
”
should be activated =
“
ON
”
Operating Instructions
Fcontrol
–
model series FKDM25/32AM-C
Programming
L-BAL-E214-GB 1446 Index 002
Part.-No.
37/99