Zetor COMPAX CL Series, Руководство оператора, Страница: 67 / 114

Engine Warm-up in Cold Weather
Cold weather changes the viscosity of the oil, resulting in a reduction in the performance of the engine oil
pump, which can cause engine damage if oil is not heated properly.
At the same time, there may be problems with the hydraulic system and synchronization in the transmission.
Warming Up Time
Make sure the parking brake is applied during warm-up.
Insufficient warm-up may cause problems or shorten the life of relevant components.
Never idle the engine in a poorly ventilated area. This can cause carbon monoxide poisoning.
Engine Running-in Time
For the initial 50 hours of operation,follow the instructions below.
1. Avoid stopping the engine suddenly.
2. Do not run the engine at high speed or with excessive load.
3. Only drive the tractor when the engine is warmed up to operating temperature.
4. Do not idle the engine at maximum speed.
5. Check all components and replace the prescribed operating fillings after 50 hours of operation, see section
Maintenance.
Driving the Tractor Off
1. Make sure the left and right brake pedals are connected when not working in the field.
2. Lift the implement.
3. Move the main shift lever, speed range shift lever, and reverse shift lever to the desired positions.
4. Release the parking brake by depressing the brake pedal.
5. Slowly release the clutch pedal while depressing the fuel control pedal to increase engine speed.
When driving, change gears only with the (main) gear shift lever and always with the clutch pedal fully
depressed.
Caution:

Do not ''ride'' the clutch to control speed, use a lower gear.

Do not travel with your foot on the clutch pedal.
Attention!

The reverse speed is almost the same as the forward speed.

Never reverse with the speed range shift lever in H position.
Temperature Time for warming up
Above 50 °F 5~10 min.
50 °F~32 °F 10~20 min.
32 °F~14 °F 20~30 min.
14 °F~-4 °F 30~40 min.
Below -4 °F Over 40 min.
DRIVING OPERATION
66