Zeta Alarm Systems.
Classic 2000 Mk II Operation Manual
Revision 1.0
Part # MAN-Z3K-01
Page 84
6.7 Serial Device Enclosure Installation Procedures
6.7.1 Serial Device Enclosure Installation
Refer to the Serial Device for complete Installation Instructions
6.7.2 Single Device Installation
The following hardware is required for installing a single device:
Four ½" nylon snap-in stand-offs
One ZFZA/ZTZB/ZRPC
Install the four ½" nylon snap-in stand-offs by screwing them onto the four studs in the upper por-
tion of the cabinet. Refer to the ZSDE enclosure drawing for mounting location. Attach the ZFZA/
ZTZB or ZRPC into the cabinet by pressing the unit onto the snap-in stand-offs.
6.7.2.1 Dual Device Installation
The following hardware is required for installing multiple devices:
Four ½" nylon M/F stand-offs
Four 1" nylon snap-in stand-offs
Two ZFZA/ZTZB
Install the four ½" nylon M/F stand-offs by screwing them onto the four studs in the upper portion of
the cabinet. Refer to the following figure for mounting location. Attach the first ZFZA/ZTZB into the
cabinet by placing it over the M/F stand-offs and securing it by screwing the 1" nylon snap-in
stand-offs onto the M\F stand-offs. Attach the second ZFZA/ZTZB by pressing the unit onto the
snap-in stand-offs.
6.7.3 Installation of ZACMs
Install the first ZACM onto the ZRPC using the hardware provided and following the instructions
provided with the ZRPC.
6.7.3.1 Adding a Second ZACM
Install the second ZACM onto the top of the first ZACM using the hardware provided and following
the instructions provided with the ZRPC. Note: Make sure pins are lined up when boards are
stacked and power is off.
Figure W-17
