Zero88 FROG 2, Руководство по эксплуатации

Страница: 95 / 184

Programming
Frog 2 Operating Manual – Issue 4.3 Page 95
Wheel Editing Modes
The desk provides a number of wheel editing modes which are user selectable and apply
when editing several fixtures at the same time. For each attribute there is an unshifted
and a shifted wheel mode.
The unshifted wheel mode is applied when the control wheel is moved. The shifted wheel
mode is applied when the SHIFT key is held down and the wheel is moved.
The shifted wheel mode for the currently selected attribute is displayed on the touch
screen. To change the editing mode, press the soft key on the touch screen, and then
select the required edit mode from the options displayed in the popup menu.
The different wheel editing modes are described below:
Absolute Mode
When several fixtures are selected and a fixture parameter is adjusted using a control
wheel, the adjusted parameter for all the selected fixtures goes to the same absolute
value. For example – Select fixtures 1 – 5 and adjust a parameter:
Fixture Parameter Fixture 1 Fixture 2 Fixture 3 Fixture 4 Fixture 5
Original Value 30 20 40 10 50
New Value 15 15 15 15 15
Change in Value -15 -5 -25 +5 -35
Relative Mode
When several fixtures are selected and a fixture parameter is adjusted using a control
wheel, that parameter on each of the selected fixtures will increase or decrease by the
same amount from its original value. This mode is most often used for adjusting position
parameters (pan and tilt) For example:
Fixture Parameter Fixture 1 Fixture 2 Fixture 3 Fixture 4 Fixture 5
Original Value 10 20 30 40 50
New Value 15 25 35 45 55
Change in Value +5 +5 +5 +5 +5