Zero88 FROG 2, Руководство по эксплуатации

Страница: 91 / 184

Programming
Frog 2 Operating Manual – Issue 4.3 Page 91
Attribute Selection Bar
The fourth row of buttons is the Attribute Selection Bar and indicates which parameters
will be recorded for each of the different attributes (Intensity, Position, Colour, Beamshape
and Effects).
Pressing each of the soft buttons on the touch screen cycles round the three options for
that attribute, except when they are forced to red (see below). The options are indicated by
the background colour as follows:
Grey Green Red
No Parameters Tagged Parameters All Parameters
When [Snapshot] or [All Parameters] are selected – all the attribute buttons are forced to
red and are no longer editable.
When recording data to cues, UDFs or UDK’s - the attribute selection bar initially shows
green (tagged) for each attribute in which one or more parameters of that attribute are
tagged and grey (none) for those attributes where no parameters are tagged.
When recording data to palettes - the attribute selection bar shows green (tagged) for the
attribute being recorded and none (grey) for all the other attributes. You can change this
selection as required before saving the data to the palette.
For example – Select some moving fixtures and set the intensity to full, the colour wheel to
blue and the gobo wheel to the desired gobo. To save the intensity, colour and gobo data
to a Beamshape palette enter the command RECORD BEAM N .. the Attribute Selection
Bar shows the following:
Intensity Position Colour Beamshape Effects
Press the [Intensity] and [Colour] buttons to change their state to tagged:
Intensity Position Colour Beamshape Effects
Complete the record operation by pressing the ENTER key.