Zero88 FROG 2, Руководство по эксплуатации

Страница: 84 / 184

Programming
Page 84 Frog 2 Operating Manual – Issue 4.3
Controlling Fixture Parameters
Each fixture type has it’s own set of parameters (intensity, colour, gobo, pan, tilt etc.)
which are classified or grouped together in different attributes (Position, Colour, Beam).
Once a fixture, or group of fixtures has been selected, the attribute buttons and control
wheels can be used to adjust the parameter output levels as required.
Controlling Intensity Parameters
The intensity (or brightness) parameter of the selected fixture(s) can be controlled by
entering commands directly via the numeric keypad or by using the control wheel.
Intensity levels can be set for a complete group of fixtures using the following commands:
GROUP <select group> @ N ENTER (sets the intensity output to N %)
GROUP <select group> FULL ENTER (sets the intensity output to 100 %)
Intensity levels can also be set for a single fixture or a number of fixtures within a group.
First select the group and then use any of the following commands:
1 @ N ENTER (sets the intensity output of fixture 1 to N %)
1 FULL ENTER (sets the intensity output of fixture 1 to 100 %)
2 + 3 @ N ENTER (sets the intensity output of fixtures 2 and 3 to N %)
2 + 3 FULL ENTER (sets the intensity output of fixtures 2 and 3 to 100 %)
5 THRU 10 @ N ENTER sets the intensity output of fixtures 5 to 10 to N %)
5 THRU 10 FULL ENTER sets the intensity output of fixtures 5 to 10 to 100 %)
The Intensity channel of a fixture can also be controlled using a wheel. Select the fixture(s)
required as described above and then press the POSITION attribute key (if not already
selected). The intensity parameter (dimmer) is assigned to the second finger wheel.
Use the control wheel to adjust the intensity level as required. The output value is shown
on the touch screen above the corresponding control wheel.
Note – Intensity on the Wheels
The Intensity parameter for a fixture is displayed in Position wheel group 1 alongside the
Pan and Tilt parameters.
Note – No Intensity Output ?
If the intensity output levels do not change when you send one of the above commands to
a fixture, or adjust the intensity level using the wheel, check that the GRAND MASTER
fader is at full and the BLACKOUT button is off. If the selected fixture(s) have a Shutter
parameter, check that the shutter is open.