20
PRKB24C01AG & PRKB24C01AS-OD Use, Care, and Installation Guide
K E G E R ATO R &
B E V E R A G E C O O L E R
I N D O O R & O U T D O O R
P R E S R V ™
10. Attach the opposite end of the gas line with the
pre-installed threaded nut to the keg coupler
(FIG. G). Tighten using the included wrench.
NOTE:
Make sure the clear silicon check valve is
inside the keg coupler before attaching the gas
line. See page 14 for reference.
11. Place a silicon washer on top of the keg coupler
and connect the threaded nut from the beer
line to the coupler (FIG. H). Tighten using the
included wrench.
12. Tap the keg by pulling the keg coupler handle
outwards - away from the keg coupler and
pushing it down to lock it into position (FIG. I).
Listen for the “click” of the pull handle when
it shifts into the final downward position and
your keg will be tapped.
NOTE:
The keg needs to be tapped to fit in the
kegerator, otherwise the keg coupler handle will be
too high and will prevent the keg from fitting.
Installation Instructions
Diagonal
FIG. F
FIG. G
Silicon washer
FIG. H
FIG. I
Installing the Kegerator
