ZENN
iO
AVANCE Y TECNOLOGÍA
vwww.zennio.com
11
11
General:
individual configuration of the basic functionalities of the air conditioning system
to be controlled.
Mode:
selection of the control type over the operating mode of the A/C machine.
Fan:
configuration of the features related to the fan speed of the A/C machine.
Temperature:
configuration of the parameters related to the temperature that is sent to
the A/C machine.
Thermostat:
selection and configuration of the parameters related to the thermostat, both
for Cool and heat modes.
Reset:
selection of whether to send or not the different statuses of the A/C machine to the
KNX bus after a bus power failure or after an application or parameter download.
In the following points, all the aforementioned windows are explained in detail.
2.3. GENERAL
As shown in figure 3.2, from the
General
window it is possible to configure the main
parameters of the A/C system to control. These are the following:
Model:
sets a number (between 0 and 255) associated to the model of the A/C machine
to be controlled (please consult the
Correspondence Table
at
http://www.zennio.com
).
No. of Zones:
selects how many zones are to be acclimatized (from 1 to 8). Depending
on the number established here, 7 communication objects will appear associated to each
zone (those associated to Zone 1 are enabled by default). They allow sending and/or
receiving different orders, related to the acclimatization of the zone: On/Off, Setpoint, Grille
control and reference temperature (see section 3.1).
Shut down A/C Unit if all grilles are OFF:
this parameter allows defining the behaviour
of the A/C machine when the grilles of all the enabled zones are closed. If this parameter is
enabled ("Yes"), when all the grilles are closed (all the objects "Zone x - Grille control" have
the value "0") the A/C machine will be switched off. This option may be interesting for systems
