KLIC-PA
Technical Support:
22
Figure 15. A/C Gateway. Configuration. Initial configuration.
•
Initial Configuration
[
Default
/ Custom
]:
allows setting the desired initial state
that KLIC-PA will send the A/C unit after programming or restarting the device:
➢
“Default”: the initial state will be the last one KLIC-PA is aware of.
➢
“Custom”: see section 2.4.2.
SCENES
Figure 16. A/C Gateway. Configuration. Scenes.
•
Scenes
[
disabled
/enabled
]:
allows setting up different scenes (up to 5),
consisting each of them in a set of orders to be sent to the A/C unit upon the
reception of scene trigger values through the KNX bus. See section 2.4.3.
2.4.2
INITIAL CONFIGURATION
The custom initial configuration allows setting the desired status that KLIC-PA will send
the A/C unit after downloading or restarting the device. This status is defined in terms of
on/off, mode, fan speed, flaps position and temperature setpoint.
In addition, it is possible to activate an initial sending of this status to the KNX bus.
ETS PARAMETRISATION
After selec
ting “Custom” for the
Initial Configuration
option under the Configuration tab
(see section 2.4.1), a new tab named
Initial Configuration
is displayed with the
following parameters:
