KLIC-DI VRV
http://www.zennio.com
Technical Support:
http://support.zennio.com
24
In case of leaving this option disabled, any orders received that imply
switching to mode “Auto” will be ignored. This not only affects to the
aforementioned objects, but also to scenes consisting in switching to the
“Auto” mode, as well as to the custom initial configuration.
Note
:
wired control models BRC1E51A7, BRC1E52A7 and BRC1E53A7 do
not send the
mode “Auto” to the A/C unit (they will only send Cool or Heat
depending on which is appropriate for each case), even if the wired control
itself does show such mode as active. Consequently, the status objects of
KLIC-DI VRV will only notify the modes Cool and Heat when an order to
switch to mode Auto is sent from the wired control. The same will happen if
sent from KLIC-DI VRV working as a slave.
Individual modes
: selecting this option brings ten new 1-bit communication
objects, four of which will be associated to the reception, from the KNX bus,
of mode switch orders (
Auto
,
Cool
,
Heat
,
Fan
and
Dry
, respectively) while
the other five will be used by KLIC-DI to inform the KNX bus about the
updated state of each function, as it is sent by the A/C machine.
In case of having activated the
Individual modes
option, it will be possible to
switch from one mode to another by simply sending the value “1” to the
control object corresponding to the new mode. After that, KLIC-DI will
acknowledge the new mode by sending a “1” through the status object
(unless the machine has, for whatever reason, not changed the mode).
Equivalently, the "
Mode
" and "
Mode (status)
" one-byte objects are available
by default and permit switching between the different modes of operation as
well as checking the currently active mode, respectively.
Simplified mode
: enabling this option activates the "
Simplified Mode
" 1-bit
object. This object allows switching from the Cool and the Heat modes by
respectively sending the values “0” or “1” to the object. Associated to this
control object, a status object is also enabled. It will acquire
the value “0” for
modes
Cold
and
Dry
, and the value “1” for mode
Heat
. Switching to the
Fan
mode does not change the value of this object.
