Zelmer 01Z011, Руководство пользователя

Страница: 33 / 34

37
Close the cover by pressing it until you hear a distinctive
●
click – be careful not to get the bag caught.
ATTENTION! Do not vacuum without bag. In case if
there is no bag in the vacuum cleaner, the front cover
of the vacuum cleaner cannot be locked.
You should replace the bag, if:
a) the red field covers the bag full indicator,
b) the vacuum cleaner operates poorly,
c) the dust bag is full.
Special accessories
The following special accessories may be purchased in retail
outlets:
Parquet brush “BNB” (20)
Is used to clean and polish hard, scratch sensitive surfaces
such as wooden floors, floor panels, parquet, marble, tiles, etc.
Delicate and soft natural bristles ensure maximum vacuum
effectiveness and protects against scratching the cleaned
surface.
End of operation cleaning
and maintenance
1 Switch off the vacuum cleaner by pressing the “on/off”
button (1) .
2
Unplug the appliance.
3 Wind the cord by pressing the cord rewind button (3) .
While doing this hold the cord to make sure it is not tangled
and the plug does not hit the vacuum cleaner housing.
4 Disconnect the suction tube from the suction nozzle or
brush.
5 Disconnect the suction tube from the hose.
6 Press the side button on the end of the hose, then
remove the end of the hose from the inlet hole of the vacuum
cleaner.
7
The vacuum cleaner may be stored in a vertical position
– just place the fastening hook of the combination brush
into the fastening of the combination brush. The hose may
be connected to the vacuum cleaner. Yet it is necessary to
make sure it is not bent to hard during storing time.
Horizontal storage:
place the fastening hook of the combination brush into
–
its fastening placed at the back of the vacuum cleaner,
near the cord exit.
Vertical storage:
place the combination brush on the telescopic tube,
–
place the fastening hook on the telescopic tube into the
–
fastening of the combination brush placed on the bottom
of the vacuum cleaner, near the front wheel.
8 If necessary wipe the housing and the dust bag container
with a damp cloth (it may be soaked with dishwashing liquid)
and dry it or wipe until dry.
Do not use abrasive detergents or solvents.
F
Examples of problems while operating the
vacuum cleaner
PROBLEM ACTION
The dust bag is damaged. Remove the dust bag and the filters.
The suction power of the
vacuum cleaner is weak.
Replace the dust bag and the filters,
check the suction tube, the hose and
the nozzle ­ remove the cause of the
clogging.
The electrical installation
fuse went out.
Check if other appliances are not
plugged to the same electrical circuit
as the vacuum cleaner. If the fuse
goes out repeatedly, return the vacuum
cleaner to a service point.
The vacuum cleaner does
not operate; the housing or
the cord is damaged.
Return the vacuum cleaner to
a service point.
Ecology – Environmental protection
Each user can contribute to protect the environment.
It is neither difficult nor expensive. In order to do so:
Return cardboard packages to recycling points.
Throw polyethylene (PE) bags into appropriate
containers.
Return a worn out appliance to an appropriate
collecting point as the components of
the appliance may pose a threat to the
environment.
Do not dispose of with household waste!!!
The manufacturer/importer does not accept any liability for any
damages resulting from unintended use or improper handling.
The manufacturer/importer reserves his rights to modify the product
any time in order to adjust it to law regulations, norms, directives,
or due to construction, trade, aesthetic or other reasons, without
notifying in advance.