14
Operation
626140-9149-911
Operating manual TEMPAR console V9.0
3 Operation
For set-up, settings and commissioning, see the TEMPAR installation
instructions.
3.1
Switching on
The TEMPAR system is always on and not switched off at the end of the
work day. Sensors can also be replaced during ongoing operation. The
calibration and sensor data are regularly read out.
Fig. 3:
Button on the underside of the console
To switch on the system, press the pushbutton on the bottom of the
console (see fig. 3). The system starts up by itself. The sensors must be
correctly connected to the system via the sensor bus (see TEMPAR
installation instructions).
There may not be any per-hour and per-day measured values present
directly after switching the system on. They must first be collected for the
corresponding time frame, before valid gradients can be displayed.
